Fire Replica base

[lad3der]

I'd like to remove my Fire Replica Miami engine from it's base. Except for a hand written card, there is no booklet or paperwork. And the base doesn't look like it comes apart easy. So, before I destroy it, has anyone taken one off the base yet? Thanks for any help.

[J-M]

I have taken a few off (and discussed this with Nick ...) as this is my only issue with FR models. I understand why he does this, though, and have discussed an alternative which I mean to draw up. I have a hard time damaging any part of a model or packaging, but I do prefer them off. The best way I have found is to cut a flap in the cardboard / fabric base around each screw head and fold it back to expose the screw head. I then rest the base on its side and support the fire engine and remove the screws. I am loathe to do this, but the way I have built my cabinets I enjoy having the models displayed with the others. It does however, permanently damage the packaging which causes the collector in me to squirm.

J-M

[Hoser]

I have taken over a dozen off their bases, and have perfected it pretty well.The bottom piece is glued on and can be removed if you carefully cut around the perimeter and work inward. Once the screws are exposed you are good to go and just have to punch holes in the bottom plate and reglue it to the wood bottom. The only visible difference is 2 small screw heads visible from the bottom when completed. Foam glue from Hobby Lobby works great

[JoeO]

I have taken over a dozen off their bases, and have perfected it pretty well.The bottom piece is glued on and can be removed if you carefully cut around the perimeter and work inward. Once the screws are exposed you are good to go and just have to punch holes in the bottom plate and reglue it to the wood bottom. The only visible difference is 2 small screw heads visible from the bottom when completed. Foam glue from Hobby Lobby works great

Same here, Brad is right on how to do it when he says "work inward".

Here's a few pictures, this is the bottom piece, using the exacto go all the way around it. Once that is off you can see the screws, the last picture is the truck back in the case.

[J-M]

The first one I tried like that must have been bad luck - there was so much glue I could not get it off. I think I must have got an accident base ... anyway it looks like this one went back on well. Very good to know.

J-M

[lad3der]

Thanks guys. I greatly appreciate the info. It worked out very well.